Level-stable forced centring

Pillar plates of GOECKE have been held for more than 35 years on countless construction sites in thetunnel - proven bridge and other civil engineering outstanding.
They ensure the highest possible accuracy in the fine positioning of instruments with tolerances of less than 1/10 millimeter. In addition to high precision all the pillars of a dull job boards are not only inexpensive, but also durable and easy to set especially. Our plates are made of a highly corrosion resistant brass alloy. Compared to anodized aluminum brass is more expensive, but it also inevitable scratches lasting corrosion resistant.

We recommend the implementation of 14A with heavy cover and replaceable centering. Even with the damage to the 5/8 "-thread of the pillar remains available, a unique feature of our board!

Pillar plate 14A with protection cover

Pillar plate 14A with protection cover

The M8 screw is screwed through the centring bolt into the plate. After the measurements are done the protection lid is fixed here.

Pillar plate for 14A for Tachylock

Pillar plate for 14A for Tachylock

Like plate 14A, these plates are also made of brass; however they have no protective cover and no replaceable locating bolt.

Pillar and wall attachment for surveying instruments

Pillar and wall attachment for surveying instruments

With our new pillars and wall paper 14-GPF1 you can set up your instruments, prisms and GPS antennas without forced centering safely and accurately.

Pillar plate without protection cover

Pillar plate without protection cover

Like plate 14A, these plates are also made of brass; however they have no protective cover and no replaceable locating bolt.

Pillar plate without protective cover for dowelling

Pillar plate without protective cover for dowelling

As 14AS, brass, 160 mm x 20 mm, the fixing is done with three M8 stainless steel screws and 40 mm long brass screw anchors.

Device mounting plate with 5/8" thread

Device mounting plate with 5/8" thread

Very economical solution where many observation piers erected, but not all at the same time are "in use". The brass plate having a diameter of 160 mm and 20 mm thickness is unscrewed after the measurement, and can be used elsewhere.

Pillars of brass bolts with cap

Pillars of brass bolts with cap

On these bolts the equipment mounting plate 14F is screwed. We recommend that the bolts installed so deep that the cap protrudes only just over the top of pillars.

Face key pillar for bolts

Face key pillar for bolts

Our pillar bolts are intentionally designed so that unauthorized persons can not without a special tool to remove the cap of the bolts.

Page:  1 
Show 1 to 8 (from a total of 8 products)