Reflective targets and accessories
Reflective targets are mainly used in structural health monitoring. Especially when a lot of points are on the building marketable and must be observed or the observed points are not easily accessible, our self-adhesive reflective targets replace expensive in many cases glass prisms. It should be noted that the automatic fine pointing and automatic target recognition on reflective targets are not or only partially possible.
Trademarks are compatible with the products of the instrument manufacturer and are made from high quality reflective tape. The pressure is applied by screen printing durable weather-and UV-resistant.
When applied to rough surfaces, the mark must be bonded to a carrier plate, which can then be plugged or glued into the wall.
We recommend the services we support plates that allow a later replacement of the mark when it should be unusable due to mechanical or weather-related influences.
The achievable ranges and accuracies are different depending on instrument.
As average values, the following values are assumed:
Trademarks are compatible with the products of the instrument manufacturer and are made from high quality reflective tape. The pressure is applied by screen printing durable weather-and UV-resistant.
When applied to rough surfaces, the mark must be bonded to a carrier plate, which can then be plugged or glued into the wall.
We recommend the services we support plates that allow a later replacement of the mark when it should be unusable due to mechanical or weather-related influences.
The achievable ranges and accuracies are different depending on instrument.
As average values, the following values are assumed:
| Shortest / maximum target distances | Accuracy / standard deviation |
|---|---|
| Minimum focus (all types): | about 10 m measurement beam perpendicular: <1.0 mm |
| Mark Size 60 x 60 mm: ca.150 m | horizontal gradient of <50 gon: <1.0 mm |
| Mark Size 40 x 40 mm: ca. 90 m | vertical gradient of <50 gon: <1.0 mm |
| Mark Size 20 x 20 mm: ca. 50 m |
The special design of the target character allows an easy and quick to focus on the brand center even from great distances, in which thin concentric rings and a cross hair no longer would be clearly identifiable.
The destination image of these brands are in the same or similar form in almost all instrument manufacturers.
High quality reflective tape with adhesive mark back, ideal for all smooth surfaces.
Our support plates of aluminum should be used if reflex targets are to be mounted on rough and / or uneven surfaces.
This carrier board is perpendicular to the surface for the installation of reflective targets with an edge length of 60 mm.
Our maxi reflex target is designed for distances from 400 to 500 m (depending on the device)...
Page: 1
Show 1 to 6 (from a total of 6 products)
