Glue, mortar and accessories

When installing levelling bolts, positive centering and assembly of targets you need specially tailored to the application, adhesives and mortar. We would like to give a few hints and recommend products that have worked well in practice. If you follow these tips, the result will meet the highest requirements.
Absolute requirement for a firm grounding or bonding is a clean, dry, grease-free and sustainable, especially underground. Please refer the instructions for the specific application

NIVELLEMENTBOLZEN, FORCED
  • The hole for the (the) anchors should be about two to three millimeters in diameter, larger than the largest of the anchor point, the depth should not significantly exceed the anchorage length to save adhesive or mortar.
  • After drilling the hole, you should use a blower or blow-out thoroughly by ourdrill dust residues.
GLUE DEMARCATION, AIM TRADE MARKS METER PLAN, PLAN-SKEWER, ETC.
  • Surface with a brass or stainless steel wire brush loose dirt and paint residue free
  • Underground degrease if necessary with universal thinner, acetone, etc.
  • Marking back roughen. This step is unnecessary in the following articles: No. meter tear marks 13E-1, 13E-3, No. adhesive markings 19 A-E
  • Fixing the mark with adhesive tape during the setting time of the adhesive
Which glue is suitable for which product?
Order No. 23SZ-5 13 FME 13-MK 106-IM150+345
Glue respectively mortar type Quick mineral cement Epoxy adhesive resin Mounting adhesive on MS polymer-based Polyester resin mortar
Number of components 1(+water) 2 (manual mixing) 1 2 (Static mix)
Minimum processing temperature as. +5° C as. +8° C as. +5° C as. +5° C
Processing time in minutes (at 20 ° C) as. 1-2 Min. as. 2 Min. as. 5 Min. as. 4 Min.
Curing time (initial strength) 5 Min. as. 5 Min. immediately as. 60 Min.
Holding power of the adhesive low very high high high
Shelf life of open cans very good good good good
 














 
Suitability for installation 23SZ-5 13 FME 13-MK 106-IM150+345
Leveling bolts vertically good very good unsuitable very good
Leveling bolts horizontally limited limited unsuitable very good
Glue marks from Alu, vertically unsuitable very good very good unsuitable
Glue marks from Alu,  horizontally unsuitable very good very good unsuitable
Target marks made ​​of aluminum unsuitable very good very good unsuitable
Target marks made of Plastic unsuitable good very good unsuitable
Meter tear marks / measurement plaquettes unsuitable good very good unsuitable
Crack monitors / crack spies unsuitable good very good unsuitable










 
Chemical mortar

Chemical mortar

For quick and safe installation of our vertical leveling bolts.. This quick-setting cement is particularly inexpensive.

5-Minute Epoxy

5-Minute Epoxy

Particularly fast drying, initial strength after just 5 minutes. Very high adhesion to dose slightly above twin syringe.

Special mounting adhesive on MS polymer-based

Special mounting adhesive on MS polymer-based

This construction adhesive can be used in a temperature range of +5 ° C to + 40 ° C processed very easily directly from the cartridge.

2K injection mortar - for installation of leveling bolts

2K injection mortar - for installation of leveling bolts

With our two-component injection mortar, you can speed the installation of leveling bolts (horizontal and vertical).

Page:  1 
Show 1 to 4 (from a total of 4 products)