Universal wall bracket 14-TK3


These brackets can be used in any point in the tunnel profile efficiently and reliably too.

The reusable, galvanised mounting plate 14-TK3-MP is installed at any desired location in the profile using three M10 impact dowels. The three-point support gives a secure attach-ment even on uneven surfaces.The mounting plate is hardly visible and is normally left on the wall in most cases after the measurement.

For the measurement, an extension arm with a hinge arm is screwed onto the mounting plate. Reliably tightening is best done using a hammer blow on the arms of the threaded nut.

The connection between the extension arm and the mounting plate is done using a round thread, which can cope with light contamination, by sprayed concrete for example.

The bracket is mainly manufactured from stainless steel (V2A). Only the threaded part is constructed from painted steel for technical construction reasons.
You need the following tools for installation:
  •      (Cordless) hammer drill with drill Ø 10mm
  •      Ratchet
  •      SW 17 and SW 24mm sockets
  •      Hammer (to tighten the extension arm)

Wall bracket 14-TK3 scope of delivery:
Extension arm with threaded nut, hinge arm with clamp system, 5/8“ fixing screw made from stainless steel. (Without mounting plate 14-TK3-MP)

Mounting plate 14-TK3-MP scope of delivery:
Galvanised mounting plate with three-point attachment, round threaded pin, plastic protective cap for thread, 3 galvanised M10 heavy-load anchors to hammer in.
Article-No. product description material PU W EUR/piece quantity  
14-TK3 Universal wall bracket with cantilever and hinge, 5/8” screw, without mounting plate stainless steel 1 O 438,90*
14-TK3-MP Mounting plate for 14-TK3 galvanized steel with mounting material steel 1 O 45,75*
14-TK-SLD Heavy duty anchors M10x80, galvanized w. washer for mounting nut, per piece steel 1 O 1,33*
14-TK2-KN Ratchet wrench with 1/2“-drive, professional 1 O 34,75*
14-TK2-SN24 Socket, width across flats 24mm, for 1/2“ ratchet wrench, professional 1 O 8,00*
14-TK2-SN17 Socket, width across flats 17mm, for 1/2“ ratchet wrench, professional 1 O 7,70*

Products, with one (*) marked to be represented are not discountable.